Setup Options - Anti-Collision

To configure, navigate to SITE COMMAND->SETUP OPTIONS

Anti-Collision in Setup options allows you to either enable or disable the traditional Anti-Collision support for ground loops or prox sensors at the end of the Conveyor. The built in Anti-Collision supports "Halting" the tunnel when the logic determines a vehicle is approaching a stopped vehicle and will run equipment that is configured as "Leave on with Anti-Collision".

NOTE: C5000 and C6, Allow Run While Halted Control Word must be enabled.

Extra Anti-Collision Margin will add extra distance from the standard 60 inches programmed in the controller if needed.