To configure, navigate to SITE COMMAND->EDL/CIL->EDL
NOTE: Equipment Dependency List is featured in the C1000 Series, C4009+ Series, C5001+ and C6 Series Controllers only.
C5005 Controller Control Word section shown.
The Equipment Dependency List is an organization of Assets that "Depend" on a primary, or "Parent", Asset to run. This would be easily explained as something like a Hydraulic Pump that drives multiple pieces of equipment and you need to tie the interlocks for their "Extend" Outputs to the Conditions of the "Parent". Here you can assign a Parent-Child structure so that interlocks properly function and retract the brushes if the pump fails to run or throws a fault through the Network or associated Warning through Configurable Inputs. Let's begin!
First, let's select a Hydraulic Pump as the Parent for Parent #0.
Now lets configure the Child Assets that depend on the operating conditions of that Hydraulic Pump. To do this, click the little drop down arrow next to the Parent # of the Parent-Child structure you wish to modify.
Here, we have set Crossover Wrap Iteration 1 and 2 to be associated to the Hydraulic Pump, after we save these changes, the system will know to monitor the status of that pump to allow the two child dependents to operate safely! Let's go ahead and save our changes!
Comments
0 comments
Please sign in to leave a comment.